Home › Servicing & repairs › Repairs

Air conditioning repairs in London

Unit not cooling, leaking water, showing an error code or refusing to start? We repair air conditioning in homes and businesses across London, Surrey and Hertfordshire, including systems we didn’t install, from all the main brands.

Open Monday to Friday, 08:30–18:00. F-Gas registered company (FGAS3011677).

Repair prices

First hour, inc. call-out
£125 + VAT
Each extra 30 minutes
£50 + VAT
Weekends
+30%
Congestion Charge zone
+£15
Paid parking only
+£10

Before you call: three quick checks

  1. Check the mode and temperature on the remote. A unit left on heat, fan or dry, or set to a temperature close to the room’s, will seem not to work. Try cool at 20°C.
  2. Clean or check the filters. They lift out from behind the front panel on most wall units. Clogged filters are the most common reason for weak airflow.
  3. Check the breaker. If the unit is completely dead, check the circuit breaker or isolator for the air conditioning. If it trips again, leave it off and call us.

Please don’t open the outdoor unit or touch the refrigerant pipes. Refrigerant work must be done by an F-Gas certified engineer.

Common faults and what causes them

White wall-mounted air conditioner

Not cooling or heating

The unit runs but the air coming out isn’t cold, or isn’t warm in heating mode.

Usual causes: blocked filters, a dirty coil, low refrigerant from a leak, a failed sensor, or a fault in the outdoor unit.

Check first: the mode, the set temperature and the filters.

What we do: check pressures and temperatures, find any leak and repair it before recharging, and test the sensors and outdoor unit.

White wall-mounted air conditioner above a doorway

Water leaking from the indoor unit

Drips or a steady trickle from the bottom of the wall unit.

Usual causes: a blocked condensate drain or tray, a failed condensate pump, a badly sloped drain pipe, or ice forming on the coil and then melting.

Check first: switch the unit off and put a towel underneath. Check the filters, as dirty filters can cause icing.

What we do: clear and flush the drain, test or replace the pump, and fix the drain route if it doesn’t fall correctly.

Grey wall-mounted air conditioner

Won’t turn on or keeps cutting out

Nothing happens when you press the remote, or the unit stops after a few minutes.

Usual causes: remote batteries, a tripped breaker, a failed fuse or board, a faulty sensor, or a protection shutdown caused by another fault.

Check first: the remote batteries, then the breaker or isolator.

What we do: find why it is shutting down rather than just resetting it, then repair the electrical or control fault.

Engineer checking the air temperature from a wall unit

Error code flashing

A code on the display, or lights flashing in a pattern on the indoor unit.

Usual causes: a sensor, communication fault between indoor and outdoor units, high or low pressure, or a fan fault. Each brand has its own codes.

Check first: write down the code or the number of flashes, and the make and model from the label on the side of the unit.

What we do: read the code against the manufacturer’s data and test the part it points to. Telling us the code when you book helps.

Outdoor unit on wall brackets on a brick house

Strange noise or vibration

Rattling, buzzing, clicking or a new hum from the indoor or outdoor unit.

Usual causes: loose panels or fixings, a worn fan motor or bearing, debris in the outdoor unit, or a noisy condensate pump.

Check first: whether the noise comes from inside or outside, and when it happens.

What we do: tighten and re-mount, clean the outdoor unit, and replace worn fans, motors or pumps.

Ventilation ductwork in a ceiling

Bad smell

A musty or damp smell when the unit starts.

Usual causes: dirt and mould on the filters, coil or fan, or standing water in the drain tray.

Check first: the filters. If they are dirty, wash them as the manufacturer’s manual describes.

What we do: deep clean the coil, fan and drain tray with suitable cleaners and put the unit on a regular service plan.

Repair or replace?

Most faults on a system under about ten years old are worth repairing. It is worth thinking about replacement when a major part such as the compressor fails on an older system, or when a system still uses R22 refrigerant, which can no longer be used to service equipment in the UK. We will tell you honestly which makes more sense, and you can see what a new system would cost on our price guide.

Prevent the next breakdown

A yearly service catches most of these faults early: clean filters and coils, a clear drain, and checks on pressures and electrics. Servicing starts from £120 + VAT for one unit.

See servicing and maintenance

Repair questions

Do you repair systems you didn’t install?

Yes. We work on all the main brands, including Mitsubishi Electric, Daikin, Fujitsu, Mitsubishi Heavy Industries, Toshiba, LG, Panasonic and Samsung.

What does the call-out cost cover?

The first hour on site, including travel. Most diagnoses and simple repairs are done within it. After that it is £50 + VAT for each extra 30 minutes, plus any parts, which we agree with you first.

Can you fix a refrigerant leak?

Yes. We find and repair the leak first, then pressure test and recharge. Simply topping up a leaking system without fixing it just means it leaks again.

Do you work weekends?

Weekend visits can be arranged and are charged at +30%.

Do you repair commercial systems?

Yes, including offices, shops, restaurants and comms rooms. See our commercial page.

Book a repair

Call us, or book online and tell us the fault and any error code.